Right-Hand Control Arm Adjustment (Right Or Left); Adjusting The Blade Arms - Husqvarna CRT48-33K Operator's Manual

CRT 48-33K
5.8

Right-hand Control Arm Adjustment (Right or Left)

The arms should be set to be perfectly vertical. Should the arms come out of
adjustment, adjust as follows:
1. Loosen the jam nuts (d).
2. Drop the horizontal linkage (e) down to clear the bracket.
3. Shorten the linkage to move the control arms to the left.
4. Extend the linkage to move the control arms to the right.
5. After the control lever has been adjusted to the desired position, reassemble the
nut and the bolt (c) and tighten the jam nuts (d).
5.9

Adjusting the Blade Arms

When Adjust the blade arms if the machine is noticeably wobbling during operation.
Requirements Machine is stopped

Machine has been lifted with a hoist.

Support the frame with blocks while the machine is elevated

Procedure Perform the procedure below to adjust the blade arms.
1. Use the pitch adjusters to pitch the blades to a setting between 1/2 and full
pitch.
2. Measure the distance from the ground to the raised edge of each blade.
3. Adjust pitch links (a) so that measured distances on all blades vary by no more
than 4.58 mm (0.180 in.).
wc_tx002046gb.fm
a
wc_gr009292
55
Maintenance