Renaming The Stored Settings - Yamaha RX-Z11 Owner's Manual

Saving and recalling the system settings (System Memory)
y
• If you select "Zone2", "Zone3", or "Zone4" in step 3, you can select
"Memory1" to "Memory4". You can save the parameters for the
selected zone only when the zone is turned on.
• If system settings are already saved in the selected memory number,
this unit overwrite to old system settings.
• If you save the system settings to "Memory1" to "Memory4", you
can load the stored settings by pressing the corresponding
7SYSTEM MEMORY buttons (see page 118).
6
Press 9k / n repeatedly to select the group of
parameters and then press 9ENTER to select or
clear the checkbox of the group.
This unit saves the parameters in the checked groups. Refer to
"Saved parameters for the main zone" on page 117.
Memory1
Memory2
Memory3
Current selected group of the parameters
Note
If the selected zone is other than "Main", you can select "Input",
"Volume", and "Tone Control". See page 117 for details.
7
Press 9n repeatedly to select "Save" and then
9ENTER to save the current system settings to the
selected memory number.
Memory1
Memory2
Memory3
y
You can cancel the saving by pressing 9l.
Press I MENU again to exit from the GUI menu.
8
116
En
Main Save
Input/HDMI Out
✓ Audio
✓ Volume
✓
SP Config
✓ Video
✓
Option
Save
Select: ENTER
appears in red
Main Save
Input/HDMI Out
✓ Audio
✓
Volume
✓
SP Config
✓ Video
✓
Option
Save
Save: ENTER

■ Renaming the stored settings

Use this feature to rename the stored settings. The name of each
memory number appears in the GUI menu or front panel display.
Press I MENU on the remote control.
1
The top menu appears in the video monitor.
2
Press 9k / n repeatedly to select "System Memory"
and then press 9h.
The "System Memory" menu appears in the video monitor.
3
Press 9k / n repeatedly to select the desired zone
and then press 9h.
In the following example, "Main" is selected.
4
Press 9k / n repeatedly to select "Main Rename"
(example) and then 9h.
The list of the memory number appears in the video monitor.
5
Press 9k / n repeatedly to select the desired
memory number and then 9h.
The rename display appears in the video monitor.
Memory1
Memory2
Memory3
Press 9 ENTER repeatedly to select a character type
6
(CAPITAL/SMALL/LATIN CAPITAL/LATIN SMALL/
FIGURE/MARK).
7
Press 9 k / n to select the character you want to use
and 9 l / h to move to the next one.
• You can use up to 9 characters for each memory.
• Press 9 n to change the character in the following order, or
press 9 k to go in the reverse order:
CAPITAL A to Z, space
SMALL a to z, space
LATIN CAPITAL Ä, Ö, Ü, etc.
LATIN SMALL
FIGURE 0 to 9, space
MARK !, #, %, &, etc.
• Press 9 ENTER to switch between character types.
y
Press 9h repeatedly to select "RESET" and then press 9ENTER to
set the name of the memory to the initial name.
Notes
• The character types you can select differ depending on the setting in
"Language" (see page 114).
• If you set "Language" to "
characters.
CAPITAL
Memory1
OK RESET
ä, ö, ü, etc.
", you can also select Japanese