Clearing A Learned Function (Erase) - Yamaha RX-Z11 Owner's Manual

5
Press GSETUP again to exit from the setup mode.

■ Clearing a learned function (ERASE)

1
Press GSETUP using a ballpoint pen or similar
object.
"SETUP" appears in the display window (4).
SETUP
2
Press 9k / n repeatedly to select "ERASE" and then
press 9ENTER.
The remote control enters the learning mode. "ERASE" and
the name of the currently selected control area appears in the
display window (4) alternately.
ERASE
Set the operation mode selector to F SOURCE and
3
then press an input selector button (3).
"ERASE" and the name of the selected control area appears in
the display window (4) alternately.
y
• You can also select the desired control area by pressing 5SELECT
l / h repeatedly.
• If you want to erase the function learned in the AMP or TV control
area, set the operation mode selector to FAMP or FTV.
4
Press 9ENTER.
"E-KEY" appears in the display window (4).
E-KEY
5
Press and hold the button you want to clear for about
3 seconds.
If clearing is successful, "ERASE" and "OK" appears in the
display window (4).
ERASE
y
• If you continuously want to clear another function, repeat step 3.
• Once you clear a learned function, the button reverts to the factory
setting (or to the manufacturer setting if you have set remote control
codes).
6
Press GSETUP again to exit from the setup mode.
Notes
• "NG" appears in the display window (4) on the remote control if clearing
was unsuccessful.
• "ERROR" appears in the display window (4) if you press more than one
button simultaneously.
DVD
OK
Remote control features
131
En