Macro Programming Features; Recalling Programmed Macro-Operations - Yamaha RX-Z11 Owner's Manual

Remote control features
6
Press 9l / h repeatedly to move the cursor (_) to
the position you want to edit.
7
Press 9k / n repeatedly to select and enter the
desired character.
Pressing 9k changes the character as follows:
A to Z, a to z, 0, 1 to 9, space, - (minus), + (plus), / (slash) and
: (colon).
y
Pressing 9n changes the characters in reverse order.
8
Repeat steps 6 and 7 until you change all the letters
you want.
9
Press 9ENTER to set the new name.
"OK" appears in the display window (4) on the remote
control if renaming was successful.
y
When you want to rename the another name of the selected control
area, press the input selector button (3) or 5SELECT l / h
repeatedly to select the desired control area and then press 9ENTER
and then carry out the operations of steps 4 through 9.
Press G SETUP again to exit the setup menu.
10
The new name of the control area appears in the display
window (4).
HDDVD
Note
"ERROR" appears in the display window (4) on the remote control if you
press a button not indicated in the respective step, or when you press more
than one button simultaneously.
128
En

Macro programming features

The macro programming feature makes it possible to perform a
series of operations with the press of a single button. For example,
when you want to play a CD, normally you would turn on the
components, select the CD input, and press the play button to start
playback. The macro programming feature lets you perform all of
these operations simply by pressing the CD macro button. The
buttons listed as macro buttons below are factory set with macro
programs. You can also program your own macros (see page 129).

■ Recalling programmed macro-operations

POWER POWER STANDBY
TV AV
MULTI V-AUX PHONO
BD
DVD CD
HD DVD
CBL
DTV DVR
SAT
NET
TUNER DOCK
USB
SELECT MACRO
SETUP ID
MODE
SYSTEM MEMORY
1 2 3
(U.S.A. and Canada models)
1
Press HMACRO on the remote control.
MACRO
2
Press the desired macro button.
"M:the 3-letter name of the selected control area" (for
example, "M:DVD") appears in the display window (4), and
this unit transmits the programmed functions. When you press
DSTANDBY or EPOWER, "M:STB" or "M:PWR" appears
in the display window (4), and this unit transmits the
programmed functions.
3
Press HMACRO again to exit from the macro-
operation mode.
Notes
• While the remote control is running a macro program, it does not accept
any other operation until it has completed running the program (the
transmission indicator in the display stops flashing).
• Continue to aim the remote control at the component the macro is
operating until the macro operation is complete.
• If you do not complete each of the operations within 30 seconds, this unit
automatically exits from the macro-operation mode.
POWER
MD
Macro buttons
TAPE
CD-R
VCR
XM
AMP
TV
SOURCE
MACRO
ZONE
4