Maintaining The Blade; Storage; Technical Data - Grizzly EKS 710 T Original Instructions For Use

GB
2. Undo the blade fixing screw (
and take off the chain wheel cover (
6)
3. Take off the old saw chain (
The assembly and tensioning of the new
saw chain are described in the "Assembly"
chapter.

Maintaining the blade

The blade must be turned over every
8 – 10 working hours in order to guarantee
even wear (for this, see the "Initial operati-
on" chapter).
1. Switch off the equipment and discon-
nect from the mains.
2. Take off the chain wheel cover (6),
saw chain (2) and blade (3) (see pic-
ture).
3. Check the blade (3) for wear. Remove
burrs and straighten the guide sur-
faces with a flat file.
4. Clean the oil channels (32) in
order to guarantee fault-free,
automatic oiling of the saw chain
during operation.
5. Assemble the blade, saw chain and
chain wheel cover and retension the
saw chain (see the "Assembly" chap-
ter).
When the oil channels are in opti-
mum condition, the saw chain au-
tomatically sprays a little oil a few
seconds after the saw is started.

Storage

• Clean the equipment before putting it
away.
• Put on blade cover.
• Always empty the oil tank before
142
5) pauses in operation lasting several
weeks because the biological chain oil
can become resinous and block the oil
2). outlet channel.
an environmentally correct manner.
• Store the device in a dry, frost-free,
and dust-protected place and out of
reach of children.

Technical Data

Type .........................................EKS 710 T
Rated input voltage ............ 230 V~, 50 Hz
Input power ...................................... 710 W
Safety class .........................................
Protection type ................................... IP20
Chain speed .................................11,8 m/s
Weight (without guide rail + chain) ...3,8 kg
Weight (with guide rail + chain) ........4,3 kg
Oiltank ...............................................70 ml
Chain ............................ Oregon 91P033X
Chain pitch ....................................... 3/8"
Chain width ................................ 1,3 mm
Number of chain drive links ............... 33
Teeth of the sprocket chain wheel ............6
Chain bar ..Oregon 080SDEA041 (547980)
Length of the chain bar ............. 240 mm
Sawing length (max.) ................ 195 mm
Acoustic pressure level
(L ) .........................88 dB(A); K
PA
Sound power level (L
measured ......... 100,9 dB(A); K
guaranteed ............................. 104 dB(A)
Vibration ...................3,4 m/s
Technical and visual changes may be
made without notice during the course of
development.
All dimensions, directions and information
in these instructions for use are therefore
subject to change. No legal positions
based on the instructions for use can
therefore be enforced.
The specified vibration emission value
has been measured in accordance with a
Dispose of used oil in
= 3 dB
PA
)
WA
= 3 dB
WA
; K= 1,5 m/s
2
II
2