Honeywell DR Graphic Installation Instruction page 6

Hide thumbs Also See for DR Graphic:

13. Remove the old LCD display subassembly along with its wires. Make sure to carefully remove the LCD from its

place as the touch screen is located right below it.

See Figure 9.

14. Make sure that the new display subassembly has the following parts attached to it.

a. 20 pin LVDS data cable connected on back side of the LCD to LCD data connector

b. 8 pin backlight cable connected to the green coloured backlight controller PCB

c. 2x backlight cables of LCD connected to the green coloured backlight controller PCB on sides

d. Metallic bracket on which the LCD is mounted

15. Cut the cable tie of the touch screen extension cable and separate out the touch screen extension cable

16. Make sure that the speaker cable and touch screen extension cable are in their proper place.

17. Fit the LCD back in its place and align all holes of LCD bracket with bezel boss holes. When bending the touch

screen extension cable make sure that it does not extend beyond the step inside the bezel just below the gask

43-TV-33-214 iss.2 GLO May 2015 UK

Figure 9

Removing old display assembly

for replacement

Figure 10

New display assembly

Figure 2 QX recorder