Honeywell DR Graphic recorder Installation Instruction

Hide thumbs Also See for DR Graphic recorder:

Download this manual

DR Graphic recorder - Installation Instruction

Door Handle Kit Assembly

This Installation Instruction sheet is intended as a guide for replacing or installing hardware and for setting up

functionality in the recorder. Refer to the User manual for detailed operational requirements.

The DR Graphic recorders are designed for ease of assembly with minimal disturbance to the rest of the unit. If unsure,

please return the unit to your supplier for repair or upgrade.

Opening the recorder and removing the internal chassis of the recorder should only be performed under the following

circumstances:

When an item of hardware requires individual replacement.

When an item of hardware is to be retrospectively fitted.

In all other instances it is recommended that the complete unit be returned to an authorized agent or service centre. For

Agency Approved recorders the product needs to be upgraded or repaired by an Authorized Repair facility

WARNING

HAZARDOUS VOLTAGES

Disconnect all the power, CJCs and IO cabling to the recorder before removing the IO cards chassis or power supply

chassis and attempting any maintenance procedures.

SAFETY TESTS

Upon completion of service procedures detailed in this instruction verify the installation per the installation section of the

product manual.

Failure to comply with these instructions could result in death or serious injury

CAUTION

OBSERVE ANTI-STATIC PRECAUTIONS

Refer to BS EN61340-5-1: 2001. Basic specification. Protection of electrostatic sensitive devices. Full anti-static

precautions MUST be observed when in contact with the electronics of your recorder.

SAVE DATA, SETUPS AND LAYOUTS

Removal of PCBs and battery back-up will result in the loss of all non-volatile data.

Ensure all data and set-ups are saved.

Failure to comply with these instructions may result in product damage.

43-TV-33-217 iss.3 GLO Jan 2021 UK

DR Graphic Recorder

Page 1 DR Graphic recorder - Installation Instruction Door Handle Kit Assembly DR Graphic Recorder This Installation Instruction sheet is intended as a guide for replacing or installing hardware and for setting up functionality in the recorder. Refer to the User manual for detailed operational requirements.
Page 2 Before attempting to repair or upgrade a recorder, it is advisable to clear sufficient work space so components such as the front panel can be rested on the work surface without getting scratched or damaged. Replacing Old Latch Bracket 1. If the latch bracket needs replacement; remove the two screws and washers shown with black arrows. Remove the latch pin from the right side.
Page 3 4. Push the door handle out by using the wrench and pull out the latch door handle by your other hand. Remove the latch CAM and Southco spring assembly. Figure 3 — Removing both the hex nuts Fitting New Door Handle 5.
Page 4 7. Insert stud with latch spring into the door handle. See Figure 6. Figure 6 Adding stud to handle 8. Insert the washer on the stud from the other side to hold the stud in place and insert the white washer onto the latch handle as shown in Figure 7.
Page 5 11. Hold the latch cam by one hand and insert the door handle back into the door handle hole by other hand. See Figure 10. Figure 10 Adding latch handle 12. Reconnect the two hex screws using the allen wrench. Figure 11 Reconnecting hex screws...