Honeywell DR Graphic Installation Instruction page 5

Dissembling display subassembly
8. Once the hinge pins are removed separate out the display bezel assembly and case.
9. Cut the cable tie shown in Figure 8.
10. Remove the LCD data cable from LCD connector shown in Figure 8.
11. Unwrap the wires from the wire wrap.
Remove the earth braid connected on LCD bracket top side. This earth braid needs to be reused with the new
display subassembly.
12. Remove the 18x No.8/32 screws, shown in red colour in Figure 8, from the LCD bracket
43-TV-33-214 iss.2 GLO May 2015 UK
Figure 7
Dissembled display bezel
assembly
Figure 8
Removing display bracket and
LCD data cable
Cut the cable tie
Remove the LCD data cable
from LCD connector
5