Removing Cables - Honeywell DR Graphic Installation Instruction

Before attempting to repair or upgrade a recorder, it is advisable to clear sufficient work space so components such as
the front panel can be rested on the work surface without getting scratched or damaged. For display subassembly
installation/replacement it is required to remove the recorder from the mounting brackets

Removing cables

1. Open the door (Bezel side) of the unit by unlocking the latch.
2. Remove the 2x No.4/40 screws of slanted chassis plate shown in circles below in Figure 1 and remove the slanted
chassis plate.
3. Remove the slanted chassis plate on the back side of the IO card chassis.
See Figure 2.
43-TV-33-214 iss.2 GLO May 2015 UK
Figure 1
Removing slant chassis
Figure 2
Removing Cabling
inside the slant
2