Makita DVC860L Technical Information page 7

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Motor section
ASSEMBLING
(2) Mount Motor assembly to the upset Separator by inserting from Tank cover complete side. Fig. 5
Fig. 5
(39)
(42)
(34)
(42)
(34)
(45)
(43)
(40)
Groove
Rib
Square hole for
Lead wire passing
(40)
(44)
(48)
(43)
(34)
1. Assemble Motor assembly (39) to the upset
Separator (34) while fitting the groove of Rubber
ring 120 (40) to the rib of Separator (34).
2. Pass the lead wires of Motor assembly (39)
through the square hole for Lead wire passing.
3. Assemble Rear block filter (42) carefully not to
push it deeper than the height of
rib of Separator (34).
4. Make sure that Rubber ring 120 (40) fits to the rib
of Separator (34) at its groove portion.
5. Assemble Front dumper (45) aligning its V
shaped portion to the triangle portion of Tank
cover complete (43).
6. Mount Band dumper (44).
7. Attach Front dumper (45) and Band dumper (44)
to the ribs of Tank cover complete (43) while
making sure that they are flat.
7. Assemble Tank cover complete (43)
together with Float cage (48) to
Separator (34).
P 7/ 29