Makita DVC860L Technical Information page 26

W
iring diagram
Fig. D-7
Put the following lead wires and connectors
to this area.
* Closed end splices connecting Controller A's
lead wire with Controller B's lead wires
* Connector connecting Controller A's lead wire
with Controller B's lead wires
Put the Connectors
connected with
LED Circuit and
Sub controller
to this area.
Put the Closed end
splices connected
with (main) Switch
to this area.
Fix Lead wires (red) connecting (main) Switch with
Controllers A and B with these Lead wire holders.
Fig. D-8
Put sag of Lead wires connected to
Switch D2VW-01-3HS under Flag
terminal, instead of on Flag terminal.
Wiring in Separator 3
LED Circuit
Wiring in Cowling Complete
Flag terminal
Switch
D2VW-01-3HS
Do not put any lead
wires on Heatsink.
Heatsink
Controller A
Sub Rib K
controller
Do not put any Lead wires
on Rib K and Rib L.
Facing Pin for ON-OFF to Switch button side,
mount Switch D2VW-01-3HS to Cowling complete.
Otherwise, impossible to operate the Switch
with Switch button.
Pin for ON-OFF
Switch
D2VW-01-3HS
Cowling complete
P 26/ 29
Flag receptacles have to be
so connected that their Lead
wires can be guided out to
the direction as shown below.
Do not put any lead wires
between (main) Switch and
Rib K.
(main) Switch
Put sag of Lead
wires into the
space inside Rib I.
Rib I
Rib L
Switch button