Ntp-A120 Install An External Wire-Wrap Panel To The Aep, Page - Cisco ONS 15454 Install

Chapter 1 Install the Shelf and Backplane Cable
Complete the
Step 4
the EIA/TIA-232 port on the TCC2/TCC2P) are required to access TL1 using the craft interface.
Caution
Complete one of the following:
Step 5
•
•
•
Stop. You have completed this procedure.
NTP-A120 Install an External Wire-Wrap Panel to the AEP
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Position the lower cover over the AEP. Make sure that the AEP AMP Champ connectors protrude
Step 1
through the cutouts in the lower cover
78-18537-01
"DLP-A22 Install the TL1 Craft Interface" task on page 17-29
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the
wristband cable into the ESD jack located on the lower-right outside edge of the shelf
assembly.
If you installed an AEP, continue with the
AEP" procedure on page 1-17.
If you did not install an AEP and you plan to install electrical cards, continue with the
Install the Electrical Card Cables on the Backplane" procedure on page
If you did not install an AEP and do not plan to install electrical cards, continue with the
Install the Rear Cover" procedure on page
This procedure connects an external wire-wrap panel to the AEP to provide
the physical alarm contacts for the AEP.
External wire-wrap panel
NTP-A119 Install the Alarm Expansion Panel, page 1-13
As needed
Onsite
None
NTP- A120 Install an External Wire-Wrap Panel to the AEP
"NTP-A120 Install an External Wire-Wrap Panel to the
1-23.
(Figure 1-5).
Cisco ONS 15454 Procedure Guide, Release 8.5.1
as needed. Craft wires (or
"NTP-A9
1-22.
"NTP-A11
1-17