Cisco ONS 15454 Install page 23

Chapter 1 Install the Shelf and Backplane Cable
NTP-A10 Route Electrical Cables
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Complete the
Step 2
Continue with the
Step 3
Stop. You have completed this procedure.
NTP-A11 Install the Rear Cover
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Identify the EIA type where you will install the rear cover.
Step 1
According to
Step 2
standoff and attach the other standoff(s) to that standoff to create an extended standoff. You should
assemble two extended standoffs for each side, for a total of four extended standoffs per shelf.
78-18537-01
This procedure routes and manages electrical (backplane) cables.
RG179, RG59 (735A) #26 AWG cable, or RG59 (734A) #20 AWG cable
NTP-A9 Install the Electrical Card Cables on the Backplane, page 1-22
As needed
Onsite
None
"DLP-A28 Route Coaxial Cables" task on page 17-37
"DLP-A29 Route DS-1 Twisted-Pair Cables" task on page 17-38
"NTP-A11 Install the Rear Cover" procedure on page
This procedure explains how to install the rear cover.
#2 Phillips screwdriver
5/16-inch nut driver
Shelf accessory kit (53-2329-XX)
Two mounting bars (700-19701-XX)
•
Four 1-inch standoffs (50-1193-01)
•
Four 1 3/8-inch standoffs (50-1492-01)
•
• Eight 2-inch standoffs (50-1453-01)
• Four flathead screws, 6-32 x 0.5 (48-2116-01)
Plastic rear cover (700-06029-XX)
NTP-A3 Open and Remove the Front Door, page 1-6
Required
Onsite
None
Table 1-4, assemble the extended standoffs for that EIA type. Start with a 1 3/8-inch
NTP- A10 Route Electrical Cables
as needed.
1-23.
Cisco ONS 15454 Procedure Guide, Release 8.5.1
as needed.
1-23