Cisco ONS 15454 Install page 15

Install the shelf and backplane cable

Hide thumbs Also See for ONS 15454:

Table of Contents

Chapter 1 Install the Shelf and Backplane Cable

Figure 1-3

Insert and tighten three screws to secure the AEP to the backplane.

Step 4

Connect the AEP cable to the backplane and AEP:

Step 5

Connect the 10 colored wires to the wire-wrap pins on the backplane.

cable wires are connected.

Plug the other end of the AEP cable into AEP connector port. The brown pin is on the top.

Figure 1-4

78-18537-01

Installing Standoffs and the AEP

Wires

AEP cable

Connector

Table 1-1

AEP Wire-Wrap Connections to Backplane Pins

NTP- A119 Install the Alarm Expansion Panel

shows AEP and AIC-I signals that each wire carries.

Cisco ONS 15454 Procedure Guide, Release 8.5.1

Figure 1-4

shows where the

1-15

Table of Contents