Installation - Honeywell MPA2 Installation Manual

Installing the MPA2 Panels

Installation

3.0 Installation
Perform the following steps to install the MPA2 Compact panel:
1. Connect the Ethernet cable as shown below:
2. Set DIP switch settings for the panel address, communication
3. Check all wiring at this time.
and result in a loss of warranty.
4. Apply power to the panel.
5. Check for the Run LED for a successful power-up. If the LED is
12 www.honeywell.com
Use a static strap whenever touching the panel to ensure
Warning:
protection from Electrostatic Discharge (ESD).
termination and biasing. See
Improper wiring can cause damage to the MPA2 at power up
Caution:
blinking green, the panel is powered up successfully.
DIP Switch Settings, page 32.