Usb Connection - Honeywell MPA2 Installation Manual

You should ground each MPA2 Standard (Metal) Enclosure panel
Note:
individually with an Earth Ground.

4.2 USB Connection

Figure 13: MPA2 USB Connection
The USB connection is intended to be used for system maintenance
Note:
and troubleshooting.
You should ground each MPA2 Standard (Metal) Enclosure panel
Note:
individually with an Earth Ground.
MPA2 Access Control Unit Installation Guide, Document 800-25395 - B
USB
Terminal
MPA2
Panel
EG
RS485
DIP Switch Settings
S1-S5: Panel Address
S6: OFF
S7: OFF
S8-S9: OFF: 485 Termination OFF
NetAXS-123
Panel
EG
Installing the MPA2 Panels
USB A Male or Micro B Male (16 ft)
DIP Switch Settings
SW5-9: Panel Address
SW3: ON: Primary
SW4: OFF: Follow User-Configured IP
S1 7-8: ON: 485 Termination ON
DIP Switch Settings
SW5-9: Panel Address
SW3: OFF
SW4: OFF
S1 7-8: ON: 485 Termination ON
MPA2
Panel
EG
System Configuration
47