Cisco 7000 Hardware Installation And Maintenance page 219

Replacing the FSIP in the Chassis
There should now be four or eight port adapters installed on the FSIP. If there are not, do not install
the FSIP until you install all port adapters or until you install a blank interface processor carrier in
the FSIP slot.
Caution Do not reinstall the FSIP unless all port adapters are installed. The empty port will allow
cooling air to escape freely through the cutouts in the faceplate, which could misdirect the airflow
inside the chassis and allow components on other boards to overheat.
Handle interface processors by the handles and carrier edges only to prevent ESD damage.
Caution
Step 1 Grasp the FSIP handle with one hand and place your other hand under the carrier to support
the FSIP and guide it into the slot. (See Figure 5-2.) Avoid touching the board.
Place the back of the FSIP in the slot and align the notch on the bottom of the carrier with
Step 2
the groove in the slot. (See Figure 5-1.)
While keeping the FSIP at a 90-degree orientation to the backplane, carefully slide the
Step 3
carrier into the slot until the FSIP faceplate makes contact with the ejector levers. (See
Figure 5-1.)
Step 4 Using the thumb and forefinger of each hand, simultaneously push the top lever down and
the bottom lever up (as shown in Figure 5-1) to fully seat the FSIP in the backplane
connector.
Use a number 1 Phillips or a 3/16-inch flat-blade screwdriver to tighten the captive
Step 5
installation screws on the top and bottom of the FSIP.
Reconnect the network interface cables or other connection equipment to the FSIP interface
Step 6
ports.
When you insert the new FSIP, the console terminal will display several lines of status
Step 7
information about the OIR as it reinitializes the interfaces. Change the state of the interfaces
to up and verify that the configuration matches that of the interfaces you replaced.
Step 8 Use the configure command or the setup command facility to configure the new interfaces.
You do not have to do this immediately, but the interfaces will not be available until you
configure them and bring them up.
After you configure the interfaces, use the show controller serial or the show interfaces
Step 9
commands to display the status of the new interfaces.
This completes the port adapter replacement procedure. For complete command descriptions and
instructions, refer to the related software configuration and command reference documentation.
Installing and Configuring Processor Modules
Maintenance 5-215