Cisco 7000 Hardware Installation And Maintenance page 131

To ensure that the clip is not pulled off when adjacent interface processors are removed,
Step 3
position the clip parallel to the orientation of the AIP. (See Figure 3-5d.)
Figure 3-5 Installing the CAB-ATM-DS3/E3 Cable and EMI Filter Clip
Assembly—Horizontal Orientation Shown
a
To RX of switch
b
d
Note Also refer to the Asynchronous Transfer Mode Interface Processor (AIP) Installation and
Configuration configuration note (Document Number 78-1214-xx, where xx is the latest version of
the document), which ships with the AIP card and is also available on UniverCD.
White insulator
White insulator
To TX of switch
c
EMI filter
clip
Connecting Interface Cables
Installing the Router 3-127