Cisco 7000 Hardware Installation And Maintenance page 117

Task
Router mounted in rack (optional)
First power supply installed in lower bay
Second (optional) power supply installed in upper bay
AC power cord connected to AC source and router; retention clip secured
DC power cable connected to DC source and router; strain relief secured
All ejector levers checked and secure
Captive installation screws on RP, SP (or SSP), RSP7000, RSP7000CI, interface processors, and power
supplies checked
Port Configuration Worksheet completed (optional)
Network interface cables and devices connected
Flash memory card (if present) inserted all the way into PCMCIA slot
ASCII terminal attached to console port
Console port set for 9600 baud, 8 data bits, 2 stop bits, no parity
All power supplies turned on (power LED lights on each supply)
Upper/lower power LEDs light for all power supplies
System boot complete (Normal LEDs light)
RP and SP (or SSP), or RSP7000, and all interface processors operational (enabled LED indicator on SP
[or SSP] and all interface processors is on)
Console screen displays correct hardware configuration (displayed after system banner)
System ready for global and interface-specific configuration
1. Refer to the related software documentation for first-time software configuration requirements.
Component
Chassis
Accessories
Rack-mount kit
Cable management kit
Power cable
EIP port jackscrews
FEIP port jackscrews
FSIP interface cables
Optional interface cables
Description
Router chassis
The following accessories may arrive in separate shipping containers:
Two brackets, two chassis ears (each holds two captive grommets), and fasteners (screws).
Two brackets and Phillips screws for attaching the brackets to the chassis
One power cable
One jackscrew conversion kit for each Ethernet port
One jackscrew conversion kit for each Fast Ethernet port
Verify that you receive 1 of the following adapter cables for each FSIP port:
EIA/TIA-232 DTE or DCE serial port adapter cable, 1 per port required
EIA/TIA-449 DTE or DCE serial port adapter cable, 1 per port required
V.35 DTE or DCE serial port adapter cable, 1 per port required
X.21 DTE or DCE serial port adapter cable, 1 per port required
EIA-530 DTE serial port adapter cable, 1 per port required
One pair of M-30 metric thumbscrews with each cable type except V.35
AUI or Ethernet transceiver cable, 1 per EIP port required
One jackscrew conversion kit for each Ethernet AUI ports (install only if needed)
Token Ring interface cable, 1 per TRIP port required
Site Log
Verified by Date
Rec'd
Preparing for Installation 2-113