Removing And Replacing The Rp, Sp, Ssp, Rsp7000, Or Rsp7000Ci - Cisco 7000 Hardware Installation And Maintenance

Figure 5-1
a
b

Removing and Replacing the RP, SP, SSP, RSP7000, or RSP7000CI

The RP, SP (or SSP), RSP7000, and RSP7000CI do not support OIR, because they are all required
system components. Removing these boards without first shutting down the system will cause an
abrupt system shutdown and can damage or destroy memory files.
To remove or replace one of these processor modules, first shut down all system power, then follow
the procedures in the following sections, "Removing CxBus Interface Processors" and "Installing
CxBus Interface Processors."
Ejector Levers and Captive Installation Screws
Processor
module
carrier guide
Captive
installation
screw
immediately
on contact
Installing and Configuring Processor Modules
Bottom ejector lever
Stop
Processor module
slot
c
Maintenance 5-161