Honeywell Performance HDZP252DI User Manual page 92

92 | Performance Series IR 1080p IP PTZ Camera User Guide
Video Motion Detection
Parameter
Enable
Working Period
Anti Dither
Area
Manual Control
Excluded
Record
Record Delay
Send Email
PTZ
Snapshot
www.honeywell.com/security
Figure 7-1 Motion Detection - Video Detection Configuration Interface
Table 7-1 Motion Detection Configurations
Function
Check to enable motion detection.
Configure the arm/disarm schedule. Click Setup to open the Working
Period page. See
information.
The system logs and records only one event during the anti-dither
period. Choose an anti-dither period from 0 to 100 seconds.
Configure the motion detection region, its sensitivity, and area. The
default settings covers the entire area. See
Detection Area on page 94
Select the Manual Control Excluded check box to disable manual PTZ
control while the Motion Event is active.
When Record is enabled, motion detection will trigger a recording.
The system can delay stopping a recording for a specified time after the
alarm has ended. Choose a delay period from 10 to 300 seconds.
When this function is enabled, the system sends an email alert to you
when an alarm occurs. The email settings must be configured for this
feature to be used (see
Select the PTZ check box to program the camera to perform a PTZ
action, from Preset, Tour, or Pattern when the motion event is active.
Select the action from the drop-down list and then the number of the
Preset, Tour, or Pattern to perform from the second drop-down list.
Check to enable the system to save motion detection snapshot files (still
images) while the motion detection event is activated. See
65 for information about configuring where snapshots are saved.
Configuring the Working Period on page 93
Configuring the Motion
for more information.
SMTP (Email) on page
for more
59).
Path on page