Honeywell SmartVFD HVAC2 Applications Manual page 63

Monitoring menu
RE ADY RU N S TO P ALARM FAULT
RE F
M ON
PAR
SYS
FWD R EV I/O K EY PAD BUS
1
Press OK to enter
Monitoring menu
RE ADY RU N S TO P ALARM FAULT
RE F
M ON
PAR
SYS
FWD R EV I/O K EY PAD BUS
Prsess Down to
3
browse V4.5
RE ADY RU N S TO P ALARM FAULT
RE F
M ON
PAR
SYS
FWD R EV I/O K EY PAD BUS
Fig. 40. Monitoring menu display
RE ADY RU N S TO P ALARM FAULT
RE F
M ON
PAR
SYS
FWD R EV I/O K EY PAD BUS
Press Left/Right to browse
2
other Monitoring groups
RE ADY RU N S TO P ALARM FAULT
RE F
M ON
PAR
SYS
F WD R EV I/O K EY PAD BUS
Preess OK the value is
4
displayed
5
Press OK V4.5 is display
63
Monitoring values are actual values of measured
signals as well as status of some control settings.
It is visible in SmartVFD HVAC2 display, but it can
not be edited. The monitoring values are listed in
Table "Monitoring values" on page 64.
Pressing Left/Right button to change the actual
parameter to the first parameter of the next
group, to browse monitor menu from V1.x to V2.1
to V3.1 to V4.1. After entering the desired group,
the monitoring values can be browsed by
pressing UP /DOWN button, as shown in Figure
"Monitoring menu display" on page 63.
In MON menu the selected signal and its value
are alternateing in the display by pressing OK
button.
NOTE: Turn on drive power, arrowhead of main
menu is at MON, V x.x or monitor param-
eter value of Vx.x is displayed in Panel.
NOTE: Display Vx.x or monitor parameter value
of Vx.x is determined by the last show
status before power shut down. E.g., it
was V4.5, and it is also V4.5 when restart.
31-00108—07