Programming; Read/Write Of Operation Parameter Settings Area; Read Operation Parameters Settings Area (Get, Getp Command) - Honeywell 2MLF-AV8A User Manual

6.1

Read/Write of operation parameter settings area

The below program examples of read/write commands (GET/PUT) for data transfer
between CPU and I/O module. For example, configuration of internal memory, and so
on.

Read operation parameters settings area (GET, GETP command)

Type
n1 Slot number where the special module is installed
Start address of setting area of special module's Run parameters to
n2
read data.
D Device's start address with saved data to read
n3 Number of words data to read
< Difference between GET command and GETP command >
GET: Always executed with execution condition On (
GETP: Executed with execution condition of operation start (
Example
The below program example reads A/D conversion module (Base 0, Slot 3) memory
addresses 0 and 1 and transfers to D0 and D1 of CPU module.
R200 Analog Input Module 2MLF-AV8A, AC8A User's Guide
September 2010

6. Programming

Description
Honeywell
Area available
Integer
Integer
M, P, K, L, T, C, D, #D
Integer
)
)
107