Multiple Monitors In Alarm - Honeywell EchoView User Manual

8.3. Multiple Monitors In Alarm

If any other monitors on the network go into alarm while one is already in alarm, the circle
accompanying second monitor in alarm also changes to a star. However, if the monitor is not the
one currently selected, the star is unfilled:
To view a monitor's data:
Scroll up or down through the list of monitors by pressing the [Y/+] or [N/-] key. As the selection
advances down the list, each subsequent circle or star is filled (black).
Note: Only one monitor can be selected for viewing at a time.
When the icon of the monitor you want to view is highlighted, then you can make your selection.
Press [MODE]. The screen changes to show the data. For example:
Monitor
Identifier
Sensor
Location
This provides you with an overview of the alarm state, including
• The monitor's location (if it has been programmed into the FMC2000 controller)
• The type of monitor
• The type of sensor
• The type of alarm state (HIGH alarm, LOW alarm, STEL, alarm, etc.)
• The level or concentration of the substance being monitored (the unit depends on the type of
sensor)
To exit from this screen back to the main reading screen, press [MODE].
EchoView User's Guide
29
Alarm type
Sensor reading