Channel Setup - Honeywell EchoView User Manual

7.2.4. Channel Setup

All units in a network must operate on a single channel. The available channels vary by the internal
wireless modem's frequency, and channel ranges are set by RAE Systems by Honeywell to
correspond with the wireless modem frequency.
These are the modem frequencies and channel ranges:
2.4 GHz: Channels 11 through 26
Note: You can use "Form Net" to automatically have the EchoView select the least-congested
channel.
Scroll until "Channel Setup" is selected.
Press [MODE] to view or change the channel. The range of available channels is shown in
parentheses. The screen also shows the channel number, with the cursor blinking on the first digit:
Step from digit to digit from left to right by pressing [MODE]. Change a digit's value by pressing
[Y/+] to increase and [N/-] to decrease. When you press [MODE] you see a flashing "?" after the
second digit:
• Save your changes by pressing [Y/+].
• Exit without saving changes by pressing [N/-].
• Step back to the first digit by pressing [MODE].
If you have saved the channel number successfully, you see this screen:
Important! Remember that the range of allowed channels for instruments on a EchoView's network
depends on the wireless modem frequency. Therefore, you may not be able to change the channel
EchoView User's Guide
26