Advertisement
7.6.4 Automatic Network Scan
This is the function to automatically scan all slaves physically connected to master through
cable. This helps to figure out the Network Configuration easily. If you select "Auto.
Network Scan..." item from "Diagnostics," then the dialogue window where the master
address and communication speed are configured appears as shown below.
After setting up master address and communication speed, click OK button to operate the
auto scan as below.
After the automatic network scan is completed, the slave list collected by master and I/O
information and GSD file information are displayed on the network scan window as below.
This window displays information of slaves. Users check out whether this information is
matched to actual slave information. If GSD file and I/O information is not matched, or
there is no GSD file, then obtain formal GSD file provided by the manufacturer of the slave
and compose the Network by yourself.
If the scanned contents are correct, then click OK button to check out the collected
Network composition as shown below.
23
Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User's Guide
[Figure 7.6.5] Automatic network scan communication settings
[Figure 7.6.6] Display automatic network scan operation status
[Figure 7.6.7] Network scan window
Honeywell
Chapter 7 N Configurator Setting
R240
January 2019
Advertisement
