Advertisement
Chapter 10 Program Example
(2) How to set up automatically
After setting and saving the Master module as seen in [Figure 10.3.3], set access according to the
methods illustrated in [Figure 10.3.9] and [Figure 10.3.10]. After that, execute "Auto. Network Scan..."
in the "Diagnostics" menu to make the following screen appeared. Input the Master's address and its
communication speed and press the 'OK' button. Then, the module begins to scan networks.
[Figure 10.3.12] Setting of Automatic Network Scan
Through the process above, N Configurator refers to GSD file of the Slave module on the current
network and the data size of the relevant module and the address of the sending/receiving data
supported by the module are automatically set. Then, the scanned results are shown as in [Figure
10.3.13].
[Figure 10.3.13] Results of Automatic Network Scan
At this time, pressing the "OK' button will prompt setting network topology automatically as seen in
[Figure 10.3.13].
35
Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User's Guide
R220
Honeywell
January 2019
Advertisement
