Advertisement
Chapter 1 Introduction
1.4 Software
This describes on the software tool for the Pnet I/F module. For programming and application, refer to the
followings
1.4.1 Check list for the software
(1) Software list
2MLL-PMEA
2MLL-PMEC
2MLL-PMEB
(2) Selecting the CPU (Version) to use the Pnet I/F module
Item
2MLK series
2MLI series
2MLR series
Software
Note
(1) You can download the above software from our web site. In case Internet is available, visit the
nearest distributor and get the installation CD.
Web site address: http://www.lsis.com/
(2) You can program the SOFTMASTER through the RS-232C port and USB of the CPU module. For
the cable, refer to wiring diagram of the CPU module.
(3) You can configure the network system by SyCon through the "Config" port of the 2MLL-PMEA.
Only 9-pin serial port is available and simultaneous connection with SOFTMASTER is not
available.
(4) You can set the parameter by N Configurator for 2MLL-PMEB/C through the USB port of the CPU
module and connection with SOFTMASTER is available.
(5) In case you use the product other than available version, some function may not work properly. If
possible, use the recommended version and check the compatibility.
4
Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User's Guide
Item
Profibus-DP master module
Available version
Model
(recommended)
2MLK-CPUH
2MLK-CPUS
2MLK-CPUA
2MLK-CPUE
2MLK-CPUU
2MLI-CPUH
2MLI-CPUU
2MLR-CPUH/T
2MLR-XPUH/F
SOFTMASTER
SyCon
N Configurator
Honeywell
Programming tool
SOFTMASTER
V2.0
V2.0
V2.0
V2.0
V1.0
V1.0
V1.0
V1.0
V1.0
V4.2
V2.0
Configuration tool for 2MLL-PMEA
V3.1.x or later
Configuration tool for 2MLL-PMEB/C
Communication
configuration tool
Remark
R240
January 2019
Advertisement
