Advertisement
Chapter 9 P2P
9.1 Introduction
P2P can be simply used with sending/receiving device area and data size setting in SoftMaster.
There are features of P2P as below.
(1) P2P block setting:
(a) If the TRX areas are many, the block can be set up to maximum 64.
(b) Maximum 244 byte per block.
(2) Setting of P2P function:
User can set the data sending/receiving direction or diagnostic function.
(3) Setting of condition flag:
User can set the communication operating condition of each block.
(4) No. of variable:
User can set the number of sending/receiving data through P2P communication.
(5) Destination station no.:
User can set the station number of slave module that is going to communicate with.
(6) Variable setting:
User can set the read area of sending data or save area of receiving data.
Remark
1) P2P communication is required the DPv1 to both master and slave module.
1
Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User's Guide
Honeywell
Chapter 9 P2P
R220
January 2019
Advertisement
