Factory Default Configurations - Cisco ASA Series Cli Configuration Manual

Factory Default Configurations

Factory Default Configurations
The factory default configuration is the configuration applied by Cisco to new ASAs.
•
•
The factory default configuration is available only for routed firewall mode and single context mode. See
Chapter 1, "Configuring Multiple Context Mode,"
See
transparent firewall mode. For the ASA 5505, a sample transparent mode configuration is provided in
this section.
Note
In addition to the image files and the (hidden) default configuration, the following folders and files are
standard in flash memory: log/, crypto_archive/, and coredumpinfo/coredump.cfg. The date on these
files may not match the date of the image files in flash memory. These files aid in potential
troubleshooting; they do not indicate that a failure has occurred.
This section includes the following topics:
•
•
•
Restoring the Factory Default Configuration
This section describes how to restore the factory default configuration.
Limitations
This feature is available only in routed firewall mode; transparent mode does not support IP addresses
for interfaces. In addition, this feature is available only in single context mode; an ASA with a cleared
configuration does not have any defined contexts to configure automatically using this feature.
Cisco ASA Series CLI Configuration Guide
1-18
ASA 5505—The factory default configuration configures interfaces and NAT so that the ASA is
ready to use in your network immediately.
ASA 5510 and higher—The factory default configuration configures an interface for management
so you can connect to it using ASDM, with which you can then complete your configuration.
Chapter 1, "Configuring the Transparent or Routed Firewall,"
Restoring the Factory Default Configuration, page 1-18
ASA 5505 Default Configuration, page 1-19
ASA 5510 and Higher Default Configuration, page 1-23
for more information about multiple context mode.
for more information about routed and
Chapter 1 Getting Started