Cisco ASA Series Cli Configuration Manual page 734

Default Settings for IPv6 Neighbor Discovery
Default Settings for IPv6 Neighbor Discovery
Table 1-1
Table 1-1
Parameters
value for the neighbor solicitation transmission
message interval
value for the neighbor reachable time
value for the router advertisement transmission
interval
value for the router lifetime
value for the number of consecutive neighbor
solicitation messages sent during DAD
prefix lifetime
on-link flag
autoconfig flag
static IPv6 neighbor
Configuring IPv6 Neighbor Discovery
•
•
•
•
•
•
•
•
•
•
Entering Interface Configuration Mode
Configure neighbor discovery settings per interface. To enter interface configuration mode, perform the
following steps.
Cisco ASA Series CLI Configuration Guide
1-6
lists the default settings for IPv6 Neighbor Discovery.
Default IPv6 Neighbor Discovery Parameters
Entering Interface Configuration Mode, page 1-6
Configuring the Neighbor Solicitation Message Interval, page 1-7
Configuring the Neighbor Reachable Time, page 1-8
Configuring the Router Advertisement Transmission Interval, page 1-8
Configuring the Router Lifetime Value, page 1-9
Configuring DAD Settings, page 1-9
Suppressing Router Advertisement Messages, page 1-10
Configuring Address Config Flags for IPv6 DHCP Relay, page 1-11
Configuring the IPv6 Prefix in Router Advertisements, page 1-12
Configuring a Static IPv6 Neighbor, page 1-13
Chapter 1 Configuring IPv6 Neighbor Discovery
Default
1000 seconds between neighbor solicitation
transmissions.
The default is 0.
The default is 200 seconds.
The default is 1800 seconds.
The default is one message.
The default lifetime is 2592000 seconds (30 days),
and a preferred lifetime is 604800 seconds (7
days).
The flag is on by default, which means that the
prefix is used on the advertising interface.
The flag is on by default, which means that the
prefix is used for autoconfiguration.
Static entries are not configured in the IPv6
neighbor discovery cache.