Cisco ASA Series Cli Configuration Manual page 643

Chapter 1 Configuring OSPF
Command
ospf cost cost
Example:
hostname(config-interface)# ospf cost 20
ospf dead-interval seconds
Example:
hostname(config-interface)# ospf
dead-interval 40
ospf hello-interval seconds
Example:
hostname(config-interface)# ospf
hello-interval 10
ospf message-digest-key key_id md5 key
Example:
hostname(config-interface)# ospf
message-digest-key 1 md5 cisco
ospf priority number_value
Example:
hostname(config-interface)# ospf priority
20
ospf retransmit-interval seconds
Example:
hostname(config-interface)# ospf
retransmit-interval seconds
Purpose
Allows you to explicitly specify the cost of sending a packet on
an OSPF interface. The cost is an integer from 1 to 65535.
In this example, the cost is set to 20.
Allows you to set the number of seconds that a device must wait
before it declares a neighbor OSPF router down because it has not
received a hello packet. The value must be the same for all nodes
on the network.
In this example, the dead interval is set to 40.
Allows you to specify the length of time between the hello
packets that the ASA sends on an OSPF interface. The value must
be the same for all nodes on the network.
In this example, the hello interval is set to 10.
Enables OSPF MD5 authentication.
The following argument values can be set:
•
key_id—An identifier in the range from 1 to 255.
•
key—An alphanumeric password of up to 16 bytes.
Usually, one key per interface is used to generate authentication
information when sending packets and to authenticate incoming
packets. The same key identifier on the neighbor router must have
the same key value.
We recommend that you not keep more than one key per interface.
Every time you add a new key, you should remove the old key to
prevent the local system from continuing to communicate with a
hostile system that knows the old key. Removing the old key also
reduces overhead during rollover.
Allows you to set the priority to help determine the OSPF
designated router for a network.
The number_value argument ranges from 0 to 255.
In this example, the priority number value is set to 20.
Allows you to specify the number of seconds between LSA
retransmissions for adjacencies belonging to an OSPF interface.
The value for seconds must be greater than the expected
round-trip delay between any two routers on the attached
network. The range is from 1 to 65535 seconds. The default value
is 5 seconds.
In this example, the retransmit-interval value is set to 15.
Cisco ASA Series CLI Configuration Guide
Customizing OSPFv2
1-11