Resetting The Asa Services Module; Monitoring The Asa Services Module - Cisco ASA Series Cli Configuration Manual

Chapter 1 Configuring the Switch for Use with the ASA Services Module

Resetting the ASA Services Module

This section describes how to reset the ASASM. You might need to reset the ASASM if you cannot reach
it through the CLI or an external Telnet session. The reset process might take several minutes.
Detailed Steps
Command
hw-module [switch {1 |2}] module slot reset
Example:
Router# hw-module module 9 reset
Examples
The following is sample output from the hw-module module reset command:
Router# hw-module module 9 reset
Proceed with reload of module? [confirm] y
% reset issued for module 9
Router#
00:26:55:%SNMP-5-MODULETRAP:Module 9 [Down] Trap
00:26:55:SP:The PC in slot 8 is shutting down. Please wait ...

Monitoring the ASA Services Module

To monitor the ASA, enter one of the following commands:
Command
show firewall module [mod-num] state
show firewall module [mod-num] traffic
show firewall module [mod-num] version
show firewall multiple-vlan-interfaces
show firewall vlan-group
show interface vlan
Examples
The following is sample output from the show firewall module [mod-num] state command:
Purpose
Resets the ASASM.
For a switch in a VSS, enter the switch argument.
The slot argument indicates the slot number in which the
module is installed. To view the slots where the ASASM is
installed, enter the show module command.
Note
To reset the ASASM when you are already logged in
to it. enter either the reload or reboot command.
Purpose
Verifies the state of the ASA.
Verifies that traffic is flowing through the ASA.
Shows the software version of the ASA.
Indicates the status of multiple VLAN interfaces (enabled or
disabled).
Displays all configured VLAN groups.
Displays the status and information about the configured
VLAN interface.
Cisco ASA Series ASDM Configuration Guide
Resetting the ASA Services Module
1-11