Cisco ASA Series Cli Configuration Manual page 397

Chapter 1 Configuring Active/Active Failover
failover lan unit primary
failover lan interface folink GigabitEthernet0/1
failover link folink
failover interface ip folink 10.0.4.1 255.255.255.0 standby 10.0.4.11
failover group 1
primary
failover group 2
secondary
admin-context admin
context admin
description admin
allocate-interface GigabitEthernet0/2
allocate-interface GigabitEthernet0/3
config-url flash:/admin.cfg
join-failover-group 1
context ctx1
description context 1
allocate-interface GigabitEthernet0/4
allocate-interface GigabitEthernet0/5
config-url flash:/ctx1.cfg
join-failover-group 2
Example 1-2
hostname SecAppA
interface GigabitEthernet0/2
nameif outsideISP-A
security-level 0
ip address 192.168.1.1 255.255.255.0 standby 192.168.1.2
asr-group 1
interface GigabitEthernet0/3
nameif inside
security-level 100
ip address 10.1.0.1 255.255.255.0 standby 10.1.0.11
monitor-interface outside
Example 1-3
hostname SecAppB
interface GigabitEthernet0/4
nameif outsideISP-B
security-level 0
ip address 192.168.2.2 255.255.255.0 standby 192.168.2.1
asr-group 1
interface GigabitEthernet0/5
nameif inside
security-level 100
ip address 10.2.20.1 255.255.255.0 standby 10.2.20.11
Figure 1-1
1.
An outbound session passes through ASA SecAppA. It exits interface outsideISP-A (192.168.1.1).
2.
Because of asymmetric routing configured somewhere upstream, the return traffic comes back
through the interface outsideISP-B (192.168.2.2) on ASA SecAppB.
3.
Normally the return traffic would be dropped because there is no session information for the traffic
on interface 192.168.2.2. However, the interface is configured with the command asr-group 1. The
unit looks for the session on any other interface configured with the same ASR group ID.
admin Context Configuration
ctx1 Context Configuration
shows the ASR support working as follows:
Configuring Active/Active Failover
Cisco ASA Series CLI Configuration Guide
1-21