Cisco ASA Series Cli Configuration Manual page 918

Configuring the ASA for Cisco TrustSec Integration
To import a PAC file, perform the following steps:
Command
Step 1
hostname(config)# cts import-pac filepath password
value
Example:
hostname(config)# cts import-pac disk0:/xyz.pac
password IDFW-pac99
Examples
The following example shows how to import a PAC file into the ASA:
hostname(config)#cts import pac disk0:/pac123.pac password hideme
PAC file successfully imported
Configuring the Security Exchange Protocol (SXP)
Configuring the Security Exchange Protocol (SXP) involves enabling the protocol in the ASA and
setting the following default values for SXP:
•
•
•
•
Cisco ASA Series CLI Configuration Guide
1-14
The source IP address of SXP connections
The authentication password between SXP peers
The retry interval for SXP connections
The Cisco TrustSec SXP reconcile period
Chapter 1 Configuring the ASA to Integrate with Cisco TrustSec
Purpose
Imports a Cisco TrustSec PAC file.
Where filepath is entered as one of the following
exec mode commands and options:.
Single Mode
•
disk0: Path and filename on disk0
•
disk1: Path and filename on disk1
•
flash: Path and filename on flash
•
ftp: Path and filename on FTP
•
http: Path and filename on HTTP
•
https: Path and filename on HTTPS
•
smb: Path and filename on SMB
•
tftp: Path and filename on TFTP
Multi-mode
•
http: Path and filename on HTTP
•
https: Path and filename on HTTPS
•
smb: Path and filename on SMB
•
tftp: Path and filename on TFTP
Where value specifies the password used to encrypt
the PAC file. The password is independent of the
password that was configured on the ISE as part of
the device credentials.