Cisco 6000 Series Configuration Manual page 95

Configuring Link Bundling
Command or Action
Step 20 bundle port-priority priority
Example:
RP/0/RP0/CPU0:router(config-if)# bundle
port-priority 1
Step 21 no shutdown
Example:
RP/0/RP0/CPU0:router(config-if)# no shutdown
Step 22 —
Step 23
Do one of the following:
• end
•
• commit
Example:
RP/0/RP0/CPU0:router(config-subif)# end
Example:
Example:
RP/0/RP0/CPU0:router(config-subif)# commit
Step 24 Perform Step 1 through Step 23 on the remote end of the
VLAN bundle connection.
Step 25
show bundle Bundle-Ether bundle-id
Example:
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
Purpose
To add the interface to the bundle without LACP support,
include the optional mode on keywords with the command
string.
If you do not specify the mode keyword, the
Note
default mode is on (LACP is not run over the
port).
(Optional) If you set the bundle maximum-active links
command to 1, you must also set the priority of the active
link to the highest priority (lowest value) and the standby
link to the second-highest priority (next lowest value). For
example, you can set the priority of the active link to 1 and
the standby link to 2.
(Optional) If a link is in the down state, bring it up. The
no shutdown command returns the link to an up or down
state depending on the configuration and state of the link.
Repeat Step 19 through Step 21 to add more Ethernet
interfaces to the VLAN bundle.
Saves configuration changes.
• When you issue the end command, the system
prompts you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
• • Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to XR EXEC
mode.
• Entering no exits the configuration session and
returns the router toXR EXEC mode without
committing the configuration changes.
• Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Brings up the other end of the link bundle.
(Optional) Shows information about the specified Ethernet
link bundle.
Configuring VLAN Bundles
83