Cisco 6000 Series Configuration Manual page 66

Configuring an Ethernet OAM Profile
Command or Action
Step 23 action dying-gasp {disable | error-disable-interface}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
dying-gasp error-disable-interface
Step 24 action high-threshold {error-disable-interface | log}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
high-threshold error-disable-interface
Step 25
action remote-loopback disable
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
remote-loopback disable
Step 26 action session-down {disable | efd |
error-disable-interface}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
session-down efd
Step 27
action session-up disable
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
session-up disable
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
54
Purpose
Specifies the action that is taken on an interface when a
dying-gasp notification is received from the remote
Ethernet OAM peer. The default action is to create a syslog
entry.
• If you change the default, the log keyword
Note
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Specifies the action that is taken on an interface when a
high threshold is exceeded. The default is to take no action
when a high threshold is exceeded.
• If you change the default, the disable
Note
keyword option is available in Interface
Ethernet OAM configuration mode to
override the profile setting and take no
action at the interface when the event
occurs.
Specifies that no action is taken on an interface when a
remote-loopback event occurs. The default action is to
create a syslog entry.
• If you change the default, the log keyword
Note
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Specifies the action that is taken on an interface when an
Ethernet OAM session goes down.
Note • If you change the default, the log keyword
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Specifies that no action is taken on an interface when an
Ethernet OAM session is established. The default action
is to create a syslog entry.
Configuring Ethernet OAM