Cisco 6000 Series Configuration Manual page 113

Configuring Traffic Mirroring
Destination interface tunnel-ip2
==========================================
Source Interface
--------------------- ----
Te0/6/0/1/9
Te0/7/0/6/9.1
Te0/7/0/6/9.2
Te0/7/0/6/9.3
Te0/7/0/6/9.4
Te0/7/0/6/9.5
Te0/7/0/6/9.6
Te0/7/0/6/9.7
Te0/7/0/6/9.8
Te0/7/0/6/9.9
/* The following output diaplays the configured traffic mirroring sessions in detail for
the specofoed interface. */
Router#
Sat May 20 11:26:03.482 UTC
Monitor-session test3 (MPLS-IPv4)
Destination interface tunnel-ip3
Source Interfaces
-----------------
TenGigE0/7/0/6/9.200
Direction:
Port level: False
ACL match:
Portion:
Interval:
Status:
TenGigE0/7/0/6/9.199
Direction:
Port level: False
ACL match:
Portion:
Interval:
Status:
TenGigE0/7/0/6/9.198
Direction:
Port level: False
ACL match:
/* The following output displays the configured traffic mirroring sessions for the specifed
interface. */
Router# show monitor-session source interface tenGigE 0/7/0/6/9 status internal
Sat May 20 06:13:52.934 UTC
Interface TenGigE0/7/0/6/9 (0x03800370)
SPAN MA:
monitor-session test1 (MPLS-IPv4) (configured globally)
destination interface tunnel-ip2 (0x08000084)
replication direction: Rx-only
port level: False
ACL enabled (acl1)
mirroring first 0 bytes
interval: Mirror all packets
state: up
interface capsulation exists
last PFI error: Success
SPAN EA, location 0/7/CPU0:
monitor-session (MPLS-IPv4)
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
Dir Status
--------------
Rx Operational
Rx Operational
Rx Operational
Rx Operational
Rx Operational
Rx Operational
Rx Operational
Rx Operational
Rx Operational
Rx Operational
show monitor-session mon1 status detail
Rx-only
Enabled (acl101200)
Full packet
Mirror all packets
Operational
Rx-only
Enabled (acl101200)
Full packet
Mirror all packets
Operational
Rx-only
Enabled (acl101200)
Configure Traffic Mirroring
101