Configuring G.709 Parameters - Cisco 6000 Series Configuration Manual

Configuring Dense Wavelength Division Multiplexing Controllers
Command or Action
Step 9 show controllers dwdm interface-path-id optics
Example:
RP/0/RP0/CPU0:router# show controller dwdm 0/1/0/0
optics

Configuring G.709 Parameters

This task describes how to customize the alarm display and the thresholds for alerts and forward error correction
(FEC). You need to use this task only if the default values are not correct for your installation.
Before you begin
The g709 disable, loopback, and g709 fec commands can be used only when the controller is in the shutdown
state. Use the admin-state command.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
configure
controller dwdm interface-path-id
Do one of the following:
• admin-state maintenance
•
• admin-state out-of-service
commit
g709 disable
g709 fec {disable | standard}
g709 report alarm disable
Do one of the following:
• end
•
• commit
admin-state in-service
show controllers dwdm interface-path-id g709
Purpose
Displays the output power level, input power level, and
wavelength information.
Purpose
Enters global configuration mode.
Configuring G.709 Parameters
133