Cisco 6000 Series Configuration Manual page 64

Configuring an Ethernet OAM Profile
Command or Action
Step 10 frame-seconds window window
Example:
RP/0/RP0/CPU0:router(config-eoam-lm)#
frame-seconds window 900000
Step 11 frame-seconds threshold low threshold high threshold
Example:
RP/0/RP0/CPU0:router(config-eoam-lm)#
frame-seconds threshold 3 threshold 900
Step 12
exit
Example:
RP/0/RP0/CPU0:router(config-eoam-lm)# exit
Step 13 mib-retrieval
Example:
RP/0/RP0/CPU0:router(config-eoam)# mib-retrieval
Step 14 connection timeout <timeout>
Example:
RP/0/RP0/CPU0:router(config-eoam)# connection
timeout 30
Step 15
hello-interval {100ms|1s}
Example:
RP/0/RP0/CPU0:router(config-eoam)# hello-interval
100ms
Step 16
mode {active|passive}
Example:
RP/0/RP0/CPU0:router(config-eoam)# mode passive
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
52
Purpose
there are 1200 errored frames in that period (that is, 100
per million for 12 million).
(Optional) Configures the window size (in milliseconds)
for the OAM frame-seconds error event.
The range is 10000 to 900000.
The default value is 6000.
Note The only accepted values are multiples of the
line card-specific polling interval, that is, 1000
milliseconds for most line cards.
(Optional) Configures the thresholds (in seconds) that
trigger a frame-seconds error event. The high threshold
value can be configured only in conjunction with the low
threshold value.
The range is 1 to 900
The default value is 1.
Exits back to Ethernet OAM mode.
Enables MIB retrieval in an Ethernet OAM profile or on
an Ethernet OAM interface.
Configures the connection timeout period for an Ethernet
OAM session. as a multiple of the hello interval.
The range is 2 to 30.
The default value is 5.
Configures the time interval between hello packets for an
Ethernet OAM session. The default is 1 second (1s).
Configures the Ethernet OAM mode. The default is active.
Configuring Ethernet OAM