Configuring The Speed For A Management Ethernet Interface - Cisco 6000 Series Configuration Manual

Configuring the Speed for a Management Ethernet Interface

Command or Action
• or
Example:
RP/0/RP0/CPU0:router(config-if)# end
Example:
RP/0/RP0/CPU0:router(config-if)# commit
Configuring the Speed for a Management Ethernet Interface
Perform this task to configure the speed of the Management Ethernet interfaces for the RPs.
SUMMARY STEPS
1. configure
2. interface MgmtEth interface-path-id
3. speed {10 | 100 | 1000}
4. Do one of the following:
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 interface MgmtEth interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface MgmtEth
0/RP0/CPU0/0
Step 3 speed {10 | 100 | 1000}
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
16
• end
• or
• commit
Advanced Configuration and Modification of the Management Ethernet Interface
Purpose
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
• • Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to XR EXEC mode.
• Entering no exits the configuration session and
returns the router to XR EXEC mode without
committing the configuration changes.
• Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Purpose
Enters XR configuration mode.
Enters interface configuration mode and specifies the
Management Ethernet interface name and instance.
Configures the interface speed parameter.