Configuring Ethernet Interfaces; Prerequisites For Configuring Ethernet Interfaces - Cisco 6000 Series Configuration Manual

Configuring Ethernet Interfaces

This module describes the configuration of Ethernet interfaces on the Cisco NCS 6000 Series Routers.
The distributed Gigabit Ethernet, 10-Gigabit Ethernet, and Fast Ethernet architecture and features deliver
network scalability and performance, while enabling service providers to offer high-density, high-bandwidth
networking solutions designed to interconnect the router with other systems in POPs, including core and edge
routers and Layer 2 switches.
Feature History for Configuring Ethernet Interfaces
Release
Release 5.0.0
Release 5.0.1
Release 5.2.1
•
•
•
•
•
•

Prerequisites for Configuring Ethernet Interfaces

You must be in a user group associated with a task group that includes the proper task IDs. The command
reference guides include the task IDs required for each command. If you suspect user group assignment is
preventing you from using a command, contact your AAA administrator for assistance.
Before configuring Ethernet interfaces, ensure that these tasks and conditions are met:
• Know the interface IP address.
• You know how to apply the specify the generalized interface name with the generalized notation
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
Modification
This feature was introduced.
Support for Source MAC accounting was included.
Support for Link Layer Discovery Protocol (LLDP) was included.
Prerequisites for Configuring Ethernet Interfaces, on page 23
Information About Configuring Ethernet , on page 24
How to Configure Ethernet, on page 33
Configuration Examples for Ethernet , on page 44
Where to Go Next, on page 45
Additional References, on page 45
rack/slot/module/port .
4
C H A P T E R
23