Configuring The Administrative State Of Dwdm Optical Ports - Cisco 6000 Series Configuration Manual

Configuring Dense Wavelength Division Multiplexing Controllers

Configuring the Administrative State of DWDM Optical Ports

Use the following procedure to configure the administrative state and optionally set the maintenance embargo
flag.
SUMMARY STEPS
1. configure
2. controller dwdm interface-path-id
3. admin-state {in-service | maintenance | out-of-service}
4. exit
5. Do one of the following:
6. maintenance disable
7. Do one of the following:
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# config
Step 2 controller dwdm interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# controller dwdm
0/1/0/1
Step 3 admin-state {in-service | maintenance | out-of-service}
Example:
RP/0/RP0/CPU0:router(config-dwdm)# admin-state
maintenance
Step 4 exit
Example:
RP/0/RP0/CPU0:router(config-dwdm)# exit
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
• interface pos interface-path-id
•
• interface tengige interface-path-id
• end
•
• commit
Configuring the Administrative State of DWDM Optical Ports
Purpose
Enters global configuration mode.
Specifies the DWDM controller and enters DWDM
controller mode.
Specifies the transport administration state.
Exits to the previous mode.
137