Cisco 6000 Series Configuration Manual page 94

Configuring VLAN Bundles
Command or Action
• commit
Example:
RP/0/RP0/CPU0:router(config-subif)# end
Example:
Example:
RP/0/RP0/CPU0:router(config-subif)# commit
Step 15 exit
Example:
RP/0/RP0/CPU0:router(config-subif)# end
Step 16
exit
Example:
RP/0/RP0/CPU0:router(config)# exit
Step 17 configure
Example:
RP/0/RP0/CPU0:router # configure
Step 18 interface {TenGigE} interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface
GigabitEthernet 1/0/0/0
Step 19
bundle id bundle-id [mode {active | on | passive}]
Example:
RP/0/RP0/CPU0:router(config-if)# bundle-id 3
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
82
Purpose
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
• • Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to XR EXEC
mode.
• Entering no exits the configuration session and
returns the router to XR EXEC mode without
committing the configuration changes.
• Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Exits interface configuration mode.
Exits XR configuration mode.
Enters XR configuration mode.
Enters interface configuration mode for the Ethernet
interface you want to add to the Bundle.
Enter the TenGigE keyword to specify the interface type.
Replace the interface-path-id argument with the node-id
in the rack/slot/module format.
Note A VLAN bundle is not active until you add an
Ethernet interface on both ends of the link
bundle.
Adds an Ethernet interface to the bundle you configured
in Step 2 through Step 13.
To enable active or passive LACP on the bundle, include
the optional mode active or mode passive keywords in
the command string.
Configuring Link Bundling