Configuration Examples For Link Bundling - Cisco 6000 Series Configuration Manual

Configuring Link Bundling
Command or Action
Step 24 Perform Step 1 through Step 23 on the remote end of the
VLAN bundle connection.
Step 25 show bundle Bundle-Ether bundle-id [reasons]
Example:
RP/0/RP0/CPU0:router# show bundle Bundle-Ether 3
reasons
Step 26 show ethernet trunk bundle-ether instance
Example:
RP/0/RP0/CPU0:router# show ethernet trunk
bundle-ether 5

Configuration Examples for Link Bundling

This section contains the following examples:
Example: Configuring an Ethernet Link Bundle
This example shows how to join two ports to form an EtherChannel bundle running LACP:
RP/0/RP0/CPU0:router# config
RP/0/RP0/CPU0:router(config)
RP/0/RP0/CPU0:router(config-if)#ipv4 address 1.2.3.4/24
RP/0/RP0/CPU0:router(config-if)# bundle minimum-active bandwidth 620000
RP/0/RP0/CPU0:router(config-if)# bundle minimum-active links 1
RP/0/RP0/CPU0:router(config -if )# bundle maximum-active links 1 hot -standby
RP/0/RP0/CPU0:router(config-if)# lacp fast-switchover
RP/0/RP0/CPU0:router(config-if)# exit
RP/0/RP0/CPU0:router(config)#interface TenGigE 0/3/0/0
RP/0/RP0/CPU0:router(config-if)#bundle id 3 mode active
RP/0/RP0/CPU0:router(config -if )# bundle port-priority 1
RP/0/RP0/CPU0:router(config-if)# no shutdown
RP/0/RP0/CPU0:router(config)# exit
RP/0/RP0/CPU0:router(config)#interface TenGigE 0/3/0/1
RP/0/RP0/CPU0:router(config -if )#bundle id 3 mode active
RP/0/RP0/CPU0:router(config-if)# bundle
RP/0/RP0/CPU0:router(config-if)# no shutdown
RP/0/RP0/CPU0:router(config-if)# exit
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
Purpose
Brings up the other end of the link bundle.
(Optional) Shows information about the specified Ethernet
link bundle.
The show bundle Bundle-Ether command displays
information about the specified bundle. If your bundle has
been configured properly and is carrying traffic, the State
field in the show bundle Bundle-Ether command output
will show the number "4," which means the specified
VLAN bundle port is "distributing."
(Optional) Displays the interface configuration.
The Ethernet bundle instance range is from 1 through
65535.
#interface Bundle-Ether 3
port-priority 2
Configuration Examples for Link Bundling
91