Cisco 6000 Series Configuration Manual page 146

Configuring G.709 Parameters
Command or Action
Step 2 controller dwdm interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# controller dwdm
0/1/0/0
Step 3 Do one of the following:
• admin-state maintenance
•
• admin-state out-of-service
Example:
RP/0/RP0/CPU0:router(config-dwdm)# admin-state
out-of-service
Step 4 commit
Example:
RP/0/RP0/CPU0:router(config-dwdm)# commit
Step 5
g709 disable
Example:
RP/0/RP0/CPU0:router(config-dwdm)# g709 disable
Step 6
g709 fec {disable | standard}
Example:
RP/0/RP0/CPU0:router(config-dwdm)# g709 fec
disable
Step 7
g709 report alarm disable
Example:
RP/0/RP0/CPU0:router(config-dwdm)# g709 odu bdi
disable
Step 8
Do one of the following:
• end
•
• commit
Example:
RP/0/RP0/CPU0:router(config-dwdm)# end
Example:
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
134
Configuring Dense Wavelength Division Multiplexing Controllers
Purpose
Specifies the DWDM controller name in the notation
rack/slot/module/port and enters DWDM configuration
mode.
Disables the DWDM controller. You must disable the
controller before you can use the DWDM configuration
commands.
Saves configuration changes. This performs the shutdown
from the previous step. When the controller has been shut
down, you can proceed with the configuration.
(Optional) Disables the G.709 wrapper. The wrapper is
enabled by default.
Note The g709 disable command is available on the
Cisco 4-Port 10-Gigabit Ethernet DWDM PLIM
only.
(Optional) Configures the forward error correction mode
(FEC) for the DWDM controller. By default, enhanced
FEC is enabled.
(Optional) Disables the logging of selected optical channel
alarms to the console for a DWDM controller. By default,
all alarms are logged to the console.
Saves configuration changes.
• When you issue the end command, the system
prompts you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)? [cancel]:
• • Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.