Cisco 6000 Series Configuration Manual page 69

Configuring Ethernet OAM
particular interface, then you can override the profile configuration. To override certain profile settings that
are applied to an interface, you can configure that command in interface Ethernet OAM configuration mode
to change the behavior for that interface.
In some cases, only certain keyword options are available in interface Ethernet OAM configuration due to
the default settings for the command. For example, without any configuration of the action commands, several
forms of the command have a default behavior of creating a syslog entry when a profile is created and applied
to an interface. Therefore, the log keyword is not available in Ethernet OAM configuration for these commands
in the profile because it is the default behavior. However, the log keyword is available in Interface Ethernet
OAM configuration if the default is changed in the profile configuration so you can retain the action of creating
a syslog entry for a particular interface.
To see all of the default Ethernet OAM configuration settings, see the Verifying the Ethernet OAM Configuration
section.
To configure Ethernet OAM settings at an interface and override the profile configuration, perform these
steps:
SUMMARY STEPS
1. configure
2. interface [GigabitEthernet | TenGigE] interface-path-id
3. ethernet oam
4. interface-Ethernet-OAM-command RP/0//CPU0:router(config-if-eoam)# action capabilities-conflict
error-disable-interface
5. commit
6. end
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0//CPU0:router# configure terminal
Step 2 interface [GigabitEthernet | TenGigE] interface-path-id
Example:
RP/0//CPU0:router(config)# interface
TenGigE 0/1/0/0
Step 3 ethernet oam
Example:
RP/0//CPU0:router(config-if)# ethernet oam
Step 4 interface-Ethernet-OAM-command
RP/0//CPU0:router(config-if-eoam)# action
capabilities-conflict error-disable-interface
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
Configuring Ethernet OAM at an Interface and Overriding the Profile Configuration
Purpose
Enters global configuration mode.
Enters interface configuration mode and specifies the
Ethernet interface name and notation rack/slot/module/port.
Note • The example indicates an 8-port 10-Gigabit
Ethernet interface in modular services card
slot 1.
Enables Ethernet OAM and enters interface Ethernet OAM
configuration mode.
Configures a setting for an Ethernet OAM configuration
command and overrides the setting for the profile
configuration, where interface-Ethernet-OAM-command is
57