Enable Screen Blanking - Honeywell Thor CV41 User Manual

Enable Screen Blanking

After you have wired and mounted the motion switch sensor, you must enable screen
blanking in Intermec settings on the vehicle mount computer.
1. In Intermec Settings, select Device Settings > Screen >
2. In Screen Blanking on Motion, select the COM port the custom serial cable is
3. In Screen-on delay after motion stops (sec), enter the amount of time in seconds
4. Tap OK. Screen blanking is enabled.
68
Screen Blanking on Motion.
connected to.
that you want the display to turn on after the vehicle is stationary.
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Guide