Makita DCU180 Instruction Manual page 16

Lighting up the front lamps
Press the lamp button on the battery box to light up
the lamps. To turn off the lamps, press the lamp button
again.
1
2
1. Lamp button 2. Lamp
NOTE: The lamps go off if the machine is left unat-
tended for approximately 10 minutes.
NOTE: The lamps go off when the power is turned off.
NOTE: You can light up the lamps even if the lock key
is not inserted.
Adjusting the handle height
Remove the short hexagonal bolts and shoulder bolts
using the wrench included in the package, and then
three levels. Tighten the shoulder bolts and short hex-
1. Short hexagonal bolt 2. Shoulder bolt
2
NOTICE:
same height.
NOTICE:
bolts with excessive force. Tighten them with
NOTICE:
Adjusting the width of the carrier
Loosen the 4 thumb nuts, and then slide the side rails.
2
1
1. Thumb nut 2. Rail
CAUTION:
limit mark.
16 ENGLISH
2
Fix the left and right handles at the
Do not tighten the short hexagonal
Do not pinch the cords with the bolts.
1
Do not slide the rails beyond the
1
1
1