3.3 WIRING – UNSHIELDED TWISTED PAIR (UTP) OPTION, CONTINUED
7. Secure the top plate in the housing.
a. Align the tabs on the plate with the slots in the housing. See
b. Dropped/Hard Ceiling Housing: Push the field run wiring back through the
c. Push the plate up until the spring latch catches and locks the top plate. See
8. Refer to the HD6 Series User Manual to install the scan.
Rev. 1.02
access hole in the housing.
Figure
11.
Dropped/Hard Ceiling Housings: Make sure that the top plate
is secured in the housing by gently pulling on the white
connector. If the plate comes down when you gently pull on the
connector, the plate is not secured properly.
35
Figure 11.
900.0696
1-Aug-06